184
(power-on password check sum error.) (power-on 密码有误) | 1. reset the power-on password in easy-setup.
(重设power-on 密码) |
185
(the startup sequence is not valid. suspect that power was off when the startup sequence was being updated.) (系统启动顺序无效,怀疑是更新启动顺序时电源关掉) | 1. reset the startup sequence in easy-setup.
(在easy-setup 重设启动顺序) |
186 | 1. system board. (检查主板) |
190
(a depleted battery pack was installed when the power was on.)
(开机时,机内笔记本[url=http://www.wuhannb.com/Html/Photo/Class61/67_Index.html]电池[/url]已快耗尽了) | 1. go to checking the battery pack.
(更换机内笔记本[url=http://www.wuhannb.com/Html/Photo/Class61/67_Index.html]电池[/url]) |
191xx
(pm initialization error.) (pm 初始化错误) | 1. system board. (检查主板) |
192
(fan error.) (cpu 散热风扇故障) | 1. measure the voltage of the backup battery. if the
voltage is not correct, replace the backup battery.
(检查cmos 备份电池的电压,电压不行时更换电池)
2. fan (要更换cpu风扇)
3. system board (主板问题) |
195
(the configuration read from the hibernation area does not match the actual configuration.) (从休眠区域读到的系统配置信息与实际配置不同) | 1. check if the configuration was changed. for example, check if the dimm card is added.
(检查配置是否改动,内存有无增加等) |
196
(a read error occurred in the hibernation area of the hard disk drive.)
( 从硬盘的休眠区域中读写时,发生错误) | 1. run the hard disk drive test. (测试硬盘)
2. hard disk drive.(检查硬盘) |
199xx
(resume error.) | 1. system board. |
1xx | 1. system board. |
2xx (内存问题)
201: memory data error.
202: memory line error 00-15.
203: memory line error 16-23.
205: memory test failure on on-board
memory.
221: rom to ram remap error. | 1. go to memory checkout.
2. dimm card.
3. system board. |
225
(unsupported memory module.) | 1. check if the supported dimm is installed.
2. dimm card.
3. system board. |
301, 303, 304, 305, 3xx
(301: keyboard error.) (笔记本键盘故障,301这个故障经常出现,往往是笔记本刚开机时,不小心
按住键盘所造成的,一般只要重启电脑即可;) | 1. go to keyboard or auxiliary input device checkout
2. keyboard.
3. external numeric keypad.
4. external keyboard.
5. keyboard/mouse cable.
6. system board. |
601, 6xx
(601: diskette drive or controller error.)
(软驱或软驱控制器故障) | 1. go to diskette drive checkout.
2. diskette drive assembly. (软驱有没有装配好?)
3. diskette.
4. system board. (检查主板) |
602
(diskette read error.); (软驱读故障) | 1. go to diskette drive checkout
2. diskette.
3. diskette drive assembly.(软驱有没有装配好?) |
604
(unacceptable id was read from the diskette drive.); | 1. go to diskette drive checkout
2. diskette drive assembly.
3. system board. |
2402 | 1. tv out card |
24xx
(2401: system board video error.) ;(主板显示部分有问题) | 1. system board. (检查主板相关部分) |
808x
8081: pcmcia presence test failure.
(pcmcia revision number also checked.)
8082: pcmcia register test failure. | 1. pc card slot assembly.
2. pcmcia device.
3. system board. |
860x
(pointing device error when trackpoint is disabled.)
(当指点杆禁用时,外接的指点设备有故障);
8601: system bus error-8042 mouse interface.
8602: external mouse error.(外接鼠标故障);
8603: system bus error or mouse error. (总线或鼠标故障); | 1. external mouse. (检查外接鼠标);
2. external keyboard. (检查外接键盘);
3. system board.(检查主板); |
861x
(pointing device error when trackpoint is enabled.)
(当指点杆启用时,外接的指点设备有故障);
8611: system bus error-i/f between 8042 and ipdc.
8612: trackpoint error.
8613: system board or trackpoint error. | 1. reseat the keyboard cable on the sub card.
(把键盘连接主板的线,重插拔一下);
2. keyboard (检查键盘);
3. external mouse (检查外接鼠标);
4. sub card (主板上连接键盘的子卡);
5. system board (主板); |
i9990301
i9990302
i9990305
i9990301: hard disk error. (硬盘有故障);
i9990302: invalid hard disk boot record. (无效的硬盘引导纪录);
i9990305: no bootable device. (无可用的启动引导设备); | 1. check that the operating system is installed in the hard disk drive. if not, install the operating system.
(检查硬盘上有否安装操作系统);
2. reseat the boot device.(重新设置可启动的设备);
3. check the startup sequence for the correct boot device.
(检查启动顺序是否跟设备正确对应);
4. check that the operating system has no failure and is installed correctly.(检查电脑的操作系统是否安装正确); |
i9990303
(bank-2 flash rom check sum error.) | 1. system board. |
other codes not listed above. | 1. go to undetermined problems |
关于我们